Steam Trolley used for carrying cakes into and out of autoclave
The curing trolley (see the picture) is special vehicle for
shipping during the production. It is used to load
the billet after cutting to the autoclave for curing, and then move
to finished goods site, and it will load the
billet to autoclave
after being unloaded.
b) Main Technical Parameter
1, Max size
Length:6340mm Width:1495mm Height:300mm
3, Diameter of the wheel :260mm
4, Bolster bearing:80mm
Bearing The temperature resistant of the lubricant oil ＞200℃
The curing trolley is composed of 2 main parts, frame and the
1. The frame is made of steel panel with good steel and easy
2. The wheel is composed of vehicle, shaft and bearing, the rolling
is very flexible and stable.
3. It has good decoupling shaft.
d) Work Principles
The bottom of the trolley is loaded billets cutting by the 2 mould.
Attention: It should add washer to make sure it is flat between the
frame and the floor surface, to avoid the frame to lean.
The trolley runs stably on the guide and the trolley is connected
by the hook, the trolley then goes to the autoclave to cure the
billet and move the billets to the finished goods site, and then
the decouple will unload the hook.
e) Quick-wear parts
Bearing 6314 2PC